45
Chapter 4. Applying Effects to the Sound (Effects)
Chapter 4
* Parameters with an “X” or “Y” following the value will be selected when using D-FIELD to control the multi-effects (p. 33). “X” can be
controlled by moving your finger to left and right, and “Y” by moving your finger up and down.
1. 4 Band EQ (Modify the tone)
fig.MFXEQ
This is a 4 band (high, midrange x 2, low) stereo equalizer.
2. Spectrum (Add Character to the Sound)
fig.MFXSPE
This is a type of filter, which modifies the tonal character by boosting or cutting specific frequencies. It is similar to an equalizer,
but when you wish to add character to the sound, the Spectrum effect will produce a more distinctive result.
Screen Parameter Explanation Value
LOW FREQ
(LOW Frequency)
Determines the frequency of the low range. 200, 400 (Hz)
LOW GAIN Adjusts the volume of the low frequency range. -15–15
HIGH FREQ
(HIGH Frequency)
Determines the frequency of the high range. 4.00, 8.00 (kHz)
HIGH GAIN Adjusts the volume of the high frequency range. -15–15
PEAK1 FREQ
(Peaking 1 Frequency)
Determines the frequency of midrange 1. 200 (Hz)–8.00 (kHz)
PEAK1 Q
(Peaking 1Q)
Specifies the width of the frequency range affected by
midrange 1. As this setting is increased, the affected area will
become narrower.
0.5–8.0
PEAK1 GAIN
(Peaking 1 GAIN)
Adjusts the volume of midrange 1. -15–15 X
PEAK2 FREQ
(Peaking 2 Frequency)
Determines the frequency of midrange 2. 200 (Hz)–8.00 (kHz)
PEAK2 Q
(Peaking 2Q)
Specifies the width of the frequency range affected by
midrange 2. As this setting is increased, the affected area will
become narrower.
0.5–8.0
PEAK2 GAIN
(Peaking 2 GAIN)
Adjusts the volume of midrange 2. -15–15 Y
OUTPUT LEVEL Adjusts the output level from the 4 band EQ. 0–127
Screen Parameter Explanation Value
LOW-HIGH GAIN Specifies the volume change at 500 Hz and 8.00 kHz. -15–15 X
MIDDLE GAIN Specifies the volume change at 1.25 kHz. -15–15 Y
BAND WIDTH Specifies the width of the bands in which the volume will be ad-
justed.
1–5
OUTPUT PAN Specifies the panning of the sound that is output from the Spec-
trum effect.
L64–R63
OUTPUT LEVEL Specifies the volume that is output from the Spectrum effect. 0–127
To Next Page
Loading...
Need help?
General
