55
Chapter 4. Applying Effects to the Sound (Effects)
Chapter 4
* 1: 16 (16th note), 8T (8th note triplets), 16. (dotted 16th note), 8 (8th note), 4T (quarter note triplets), 8. (dotted 8th note), 4 (quarter note), 2T (half note
triplets), 4. (dotted quarter note), 2 (half note), 1T (whole note triplets), 2. (dotted half note), 1 (whole note)
* 2: 2M (2 measures), 3M (3 measures), 4M (4 measures), 8M (8 measures), 16M (16 measures)
21. Auto PAN (Automatically Move the Stereo Location)
fig.MFXAPN
This effect automatically moves the stereo location of the sound. You can cause the sound to be panned left and right in time with
low notes such as a Bass Drum, or in synchronization with the BPM of the pattern.
* 1: 16 (16th note), 8T (8th note triplets), 16. (dotted 16th note), 8 (8th note), 4T (quarter note triplets), 8. (dotted 8th note), 4 (quarter note), 2T (half note
triplets), 4. (dotted quarter note), 2 (half note), 1T (whole note triplets), 2. (dotted half note), 1 (whole note)
* 2: 2M (2 measures), 3M (3 measures), 4M (4 measures), 8M (8 measures), 16M (16 measures)
OUTPUT LEVEL Specifies the output volume from the Short Delay effect. 0–127
Screen Parameter Explanation Value
LFO TYPE Determines the waveform that will be used
to pan the sound to left and right.
TRI, TRP, SIN, SAW1, SAW2, SQR
BASS SENS Make this setting when you wish to shift the
panning at the timing of the bass notes.
OFF (the panning will change at the speed
specified by Rate),
MODE1 (the Rate value will increase at
the timing of the bass notes),
MODE2 (the panning will change at the
timing of the bass notes)
DEPTH Specifies the depth of panning. 0–127 Y
RATE Specifies the rate at which the pan will be
moved.If a note value or measure is selected
as the value of this parameter, the Rate will
synchronize with the tempo of the pattern at
intervals of the specified note value or mea-
sure.
* When the Bass Sensitivity parameter is set
to “MODE2,” the Rate setting will be
ignored.
0.1–10.0 (Hz), notes (*1), measures (*2) X
LOW GAIN Adjusts the boost or cut of the low frequency
range.
-15–15
HIGH GAIN Adjusts the boost or cut of the high frequency
range.
-15–15
OUTPUT LEVEL Specifies the output volume of the AUTO
PAN effect.
0–127
Screen Parameter Explanation Value
To Next Page
Loading...
