Roland GX-24 Manual

3-1
3 Replacement of Main Parts
The necessary adjustments after the replacement of each part, and the referential time for each work are
described as follows.
3-1 TOOL CARRIAGE_REPLACEMENT
Remove the TOOL CARRIAGE COVER.
Remove the TOP COVER and TOP PANEL.
TOP PANEL
PINCH ROLLER REPLACEMENT : 5min.
< Total Time : 5min. >
CUTTER PROTECTION REPLACEMENT : 5min.
< Total Time : 5min. >
TOOL CARRIAGE REPLACEMENT : 10min.
1. TOOL HEIGHT ADJUSTMENT
2. TOOL PRESSURE ADJUSTMENT
3. AUTO TOOL/CROP MARK SENSOR POSITION
ADJUSTMENT
Adj. Time : 55min.
< Total Time : 65min. >
MAIN BOARD REPLACEMENT : 10min.
1. FIRMWARE INSTALLATION
2. ALL INITIALIZE
3. TOOL PRESSURE ADJUSTMENT
4. CALIBRATION
5. AUTO TOOL/CROP MARK SENSOR POSITION
ADJUSTMENT
Adj. Time : 60min.
< Total Time : 70min. >
CARRIAGE MOTOR REPLACEMENT : 5min.
1. AGING Adj. Time : 1min.
< Total Time : 6min. >
GRIT MOTOR REPLACEMENT : 5min.
1. AGING Adj. Time : 1min.
< Total Time : 6min. >
TOP COVER
TOOL CARRIAGE COVER

Roland GX-24 Specifications

General

Cutting Speed	Up to 20 inches/sec (500 mm/sec)
Distance Accuracy	±0.004 inches (±0.1 mm) or less
Repeatability	±0.1 mm (0.0004 in.) or less
Interface	USB
Power Supply	AC 100-240V, 50/60Hz
Operating Temperature	5 to 40°C (41 to 104°F)
Operating Humidity	35 to 80% RH (non-condensing)
Software Resolution	0.025 mm/step (0.001 in./step)