Roland HPD-10 - Diagnostic Test Details - Factory Reset; Factory Reset Test

20
Mar. 2006 HPD-10
(12)Factory Reset [12. Factory Reset]
fig.test39.eps_35
1. Press [4 (DRUMS)] to execute Factory Reset and return the settings to
their factory default values.
fig.test40.eps_35
If any test item has failed to return OK, the following message appears in the
display.
fig.test41.eps_35
If you want to repeat any test, press [SHIFT] + [-] or [SHIFT] + [ ] to carry out
the corresponding test.
If you don’t want to repeat any test, confirm the display and then turn off the
power to the unit as is (Factory Reset is also executed in this case).
This completes the tests.
2. Turn off the power of HPD-10.
Service Notes(A4)_e 20 ページ ２００６年６月１日 木曜日 午後４時５分