30
Part 2 Performing Marking
4. Finishing
When marking ends, remove the workpiece and switch off the power.
1
Grasp the base on both sides and pull back toward you
to remove.
2
Remove the workpiece from the base.
If the workpiece is difficult to detach, inserting a thin,
flat object (such as a piece of sheet metal or a piece of
stiff paper) between the adhesive sheet and the
material may make the workpiece easier to remove.
3
Loosen the screw.
4
Load the base on the machine.
Slowly press it in inward until it makes contact.
5
Press the [STANDBY] key to switch off the power.
To Next Page
Loading...
