48
Part 5 Troubleshooting
4
Click [Test print].
The test pattern is marked on the workpiece.
5
Grasp the base on both sides and pull back toward you
to remove.
51010 1515 2020 5
5
5
10
15
20
10
15
20
6
Use the scale to read and note down locations where
the test pattern is not continuous or not visible. Note
down the values in all four directions (front, back, left,
and right).
7
Select [Correct slope] and enter the scale values you
noted into the driver.
RightLeft
Back
Front
To Next Page
Loading...
