Getting Clean Tracks
• Set the input sensitivity (volume of mic) by pressing SENS then Auto-Sens.
• Now have the subject speak, or create sound. Press ENTER when it appears.
The unit will recommend you to turn down or increase volume for optimal
levels. Use the large dials on front to adjust mic volume, watching the lower
left corner of screen for level numbers.
• Use the Limiter to keep audio from distorting. Select it in the appropriate Input
Setup menu.
• Use a Low Cut filter to reduce rumble noise. Activate it in the Input Setup
menu. Press LCF to switch it on. Press LCF Cutoff to set amount of reduction.
Higher numbers remove more low frequency audio.
To Next Page
Loading...
