Roland RD-700 - Storing Settings to Setups ([WRITE])

56
Using the Convenient Functions in Performances
Convenient Functions
Storing Settings to Setups ([WRITE])
When the contents of a Setup are changed, an asterisk (a “*” mark) appears
on the right of the tempo indication. If you want to use the changed content
as a new Setup, use the following procedure to save the settings to a Setup.
You can also change the name of a Setup.
You can store 100 Setups on the RD-700.
fig.panel
1
Press [WRITE], getting the indicator to light.
The Setup screen appears.
fig.LCD
2
Press CURSOR [ ] to move the cursor to the destination
Setup name.
3
Select the save-destination Setup, either by pressing [INC/
YES] or [DEC/NO].
When using the TONE SELECT buttons to input Setup numbers, press
[ENTER] afterwards to set the number.
4
Press CURSOR [ ] to move the cursor to the new Setup
name.
fig.LCD
CONTROL
12,4,8 3,6 359,10
New Setup Name
Destination
RD-700_e.book 56 ページ ２００４年４月２６日 月曜日 午前１１時５４分