Roland Super JX-10 - Page 18

b. Tone Number
To change
the Tones in
a Patch Memory, simply
assign
the Tone Number
of the relevant Tone by
using the Ten Keys.
PROCEDURE
(T) Push
the Upper or
the Lower Button
®
to
select
the Upper or
Lower Tone
which you
wish to change.
@
Pushing
the
appropriate Ten Keys,
assign the
new Tone
Number,
then
hit the
Enter Key.
Tone Numbers of
the
Patch
Memory currentiy
selected are displayed
Select the
Upper
or
Lower Section
, Assign
the Tone Number
you want
by using
the
Ten
Keys
iC. 11
T
A dot is shown
at the
right to the
Lower
Tone
Number
E
1 D
DU
The Tone
Number of the
Upper
Section changes
1-
ii
-
1
(C. D
1
The Tone Number of
the
Lower
Section changes
DC DU
L
f^f\ 6
"0"
of the Ten Keys can be used instead of
the
UPPER and LOWER Buttons.
Even when
using the Patch Memory of the JX-10's
internal
memory, the
Tone
Number
of the Car-
tridge can be
called.
After taking
the step (V), change
the Voice Memory
Switch
to the
CART
position.
Then return
It to the INT position
after
taking
the step
(2).
If
you call other Patch Memory
without writing it
into memory, the Tone called from the
Cartridge
memory will
be erased.
To call the Tone from the Memory
Cartridge
(M-
16C), take exactly the same
procedure as above.
The available Tone Numbers,
however, are from
1
to 32.
18