Roland Super JX-10 - Page 57

a.
Receiving and Transmiting MIDI
Messages
1)
Setting
MIDI Channels
The JX-10's MIDI allows
to
set two different
channels
separately forthe
Upper and
the
Lower
sections.
Even when
different channels
are assigned
to the
upper and the
lower, in
the Dual Key Mode, the
JX-10 wilt
be played with the Note
ON/OFF
mes-
sages (Key information)
sent on the
MIDI channel
assigned to
the upper. The
MIDI channel of the
lower is
ignored. Likewise, when the Key Mode is
the Lower
Whole, the JX-10 is
played with the
Note
ON/OFF messages of the
lower section. And
when in the
Split Key Mode, the
upper and lower
sections are
played
independently with the mes-
sages
sent on each MIDI channel.
The Program
Change messages
basically
work to
change
the Tone Numbers. Therefore,
if two diffe-
rent MID! channels are
separately set for
the upper
and the lower sections, the
Tone of each
section
can be
changed independently.
The
Program Change messages
can also change
the Patch Memories. This is fully explained later
in "Selecting
a
Patch Memory with
MIDI Program
Change".
®
Push the MIDI
of the Edit Buttons
(D.
The corresponding
indicator will light up, and the
Display will show
the MIDI
function previously
selected.
Am nnrrsi
r> I
^^
Now, using the Ten Keys
®,
assign the
number of
the MIDI Function you wish to change.
Here, it is
MIDI Channel forthe upper
section, so the
number
is
2,
0.
©
Push
2,
and
ENTER of the Ten
Keys.
d)
Using the a Dial, change
the MIDI channel
number.
To set the MIDI
channel for the lower section,
push
3,
and ENTER in the step
(2).
The MIDI channels you
have set as this
will
be
erased from the
memory of the JX-10 unless
you
follow the
writing procedure.
57