Roland Super JX-10 - Page 58

Writing Procedure
(T) Set the
Protect Switch on the JX-10
to the OFF
position.
@
Push the WRITE button
®,
then
the Enter
Key.
I /n
T T T
C
ft
'
K4
T T) T
The
Display will react as above, then
return to the
Patch
Memory indication.
CD
Return
the Protect Switch on the
JX-10 to the
ON position.
2)
Selecting
a Patch Memory with
MIDI Program
Change
You can
select a Patch Memory
using the
MIDI
program change
messages. In
this case, a MIDI
channel different from
those
used
for
the
upper
and the lower
sections is
available. This
is
useful
for when playing
the JX-10
with a
computer; you
can
change the Tones of the
upper and the tower
using corresponding channels and
change the
Patch
Memories using the third
channel (Patch
Memory CH).
*
The JX-10 is
designed to
produce no sound
while you are changing Patch
Memories. This
serves
to mute the noise which
otherwise would
be heard. If
you do not
like cutting sound,
instead of changing Patch
Memories, change
the Tones.
In this way, you
can call the sound
you like without
any silence
at all.
if you assign
the same
channels to the Patch
Memory
(Patch Memory CH) and the upper section
(Upper
MIDI CH), the Program
Change of
the
upper MIDI channel can change the Patch
Memories. In this case, however, the Tone num-
bers of
the
upper
cannot be
changed with the
Program
Change.
Only when the lower MIDI
channel
is
different
from that of the upper, the
lower Tone numbers
can be changed.
To set
the
MIDI channel for the Patch
Memory, call
the Function number 10 with the
Ten Keys and set
the channel
number (1 to 16,
OFF) with the a Dial.
Select OFF, if
you
do not need to
change Patch
Memories with the Program
Change.
58