4. Assembly and Ink Filling
26
Connect both the power cord and the Ethernet cable (commercially available).
Use a power plug adapter if the electrical outlet is a two-prong outlet.
WARNING
Connect the machine to an electrical outlet that complies with this ma-
chine’s ratings (for voltage, frequency, and current).
Incorrect voltage or insufcient current may cause re or electrical shock.
WARNING
Connect the machine to ground.
This can prevent re or electrical shock due to current leakage in the event of
a malfunction.
WARNING
Perform this task with all power switches left switched off.
Failure to observe these instructions may cause the machine to move suddenly,
resulting in injury.
CAUTION
Never insert your hand or ngers into the opening of the front cover.
The print head carriage moves at high speed inside the cover. Coming into
contact with the moving carriage may cause injury.
w
Pass the cables through the cable clamp.
Ethernet
(1000BASE-T recommended)
Ethernet cable
(Category 5 or higher)
Ethernet cable
Power cord
Never insert
a telephone
cable.
Cable clamp
Pass the cables through here.
To Next Page
Loading...
