12
Using a Kit Eect
You can use a kit eect to modify the sound of the instruments. You can choose from numerous types such as
eects that distort the sound, make it richer, or add cyclic modulation.
KIT 99
KIT 01
EFFECT
HEAD
TRIG IN 1
INST INST
RIM HEAD
TRIG IN 2
INST INST
RIM
* One kit can use only one type of kit eect.
Selecting the Eect Type
Before you continue, turn on the “EectSend” of each instrument to which you want the eect to apply. p. 11
1.
Use the [-] [+] buttons to select a kit.
2.
Press the [INST] button.
3.
Press the [>] button to select the “KIT EFFECT–Type.”
4.
Use the [-] [+] buttons to select Type.
Eect type
Type Explanation
THRU The eect won’t be applied.
DELAY Stereo delay
TAPE ECHO
A virtual tape echo that produces a realistic tape delay sound. This simulates the tape echo section of a
Roland RE-201 Space Echo.
CHORUS This applies a chorus eect.
FLANGER The anging eect gives a twisting, jet-airplane-like character to the sound.
PHASER A phase-shifted sound is added to the original sound and modulated.
EQUALIZER This adjusts the tone as a equalizer.
COMP Flattens out high levels and boosts low levels, smoothing out uctuations in volume.
WAH This produces a wah eect by modifying the lter in correspondence with the volume of the performance.
DIST This eect distorts the sound to create long sustain.
RINGMOD
This is an eect that applies amplitude modulation (AM) to the input signal, producing bell-like sounds. You
can also change the modulation frequency in response to changes in the volume of the sound sent into the
eect.
REVERB Adds reverberation to the sound, simulating an acoustic space.
5.
Press the [>] button to select an eect parameter, and use the [-][+] buttons to adjust the value.
The eect parameters dier depending on the type.
For details on the parameters ”Sound List” (PDF)
To Next Page
Loading...
Need help?
General
