Editing a portion (measure) of a
rhythm pattern that you composed
Copying measures (Copy)
[START/STOP] button before that
measure ends.
The rhythm stops. Even if the notes
are interrupted, they have been stored
to the end of the measure. The
measure at which you pressed the
[START/STOP] button will be the last
measure.
1. Use the select switch to select a
track, and press the [START/STOP]
button.
2. The moment that the measure that
you want to edit is playing, switch to
the rhythm pattern.
* To edit a fill-in rhythm, use the intro/
fill-in switch to make the switch instead
of using the [TAP] button.
* It’s not possible to change only the
number of measures in a composed
rhythm pattern. If you want to change
the number of measures, you must re-
compose from the beginning.
* Keep holding down the [TAP] button
during the copy operation. The
operation is cancelled if you release
the [TAP] button.
1. At the beginning of the copy-
destination measure, hold down the
[TAP] button.
The display indicates “COPy.”$
Example: If you select measure 5, the
data is pasted between measure 4
and measure 5.$
2. (Continuing to hold down the [TAP]
button) Press the [START/STOP]
button, and select the starting
measure of the copy-source.
The screen indicates the measure
number.$
Use the [1]–[10] buttons or the
[VALUE] knob to make the selection.
Press the [16] button to move the
measure to the last measure.
(Continuing to hold down the [TAP]
button) Press the [START/STOP]
To Next Page
Loading...
