Roland TR-08 - Page 23

Inserting measures (Ins)
Deleting measures (Del)
button, and select the ending measure
of the copy-source.$
Use the [1]–[10] buttons or the
[VALUE] knob to make the selection.$
Press the [16] button to select the last
measure.
(Continuing to hold down the [TAP]
button) Press the [START/STOP]
button to execute the copy operation.
* Keep holding down the [TAP] button
during the insert operation. The
operation is cancelled if you release
the [TAP] button.
1. At the location where you want to
insert measures, hold down the [TAP]
button and turn the [FINE] (VALUE)
knob to select “ InS.”$
Example: If you select measure 5, the
data is inserted between measure 4
and measure 5.
2. (While continuing to hold down the
[TAP] button) press the [START/
STOP] button and select the insert-
source measure.$
The screen indicates the measure
number.$
Press one of the [1]–[10] buttons or
turn the [FINE] (VALUE) knob to select
the last measure that will be inserted.
Press the [16] button to move the
measure to the last measure.
3. (Continuing to hold down the [TAP]
button) Press the [START/STOP]
button to execute the insert operation.
* Keep holding down the [TAP] button
during the delete operation. The
operation is cancelled if you release
the [TAP] button.
1. At the measure that you want to
delete, hold down the [TAP] button
and turn the [FINE] (VALUE) knob to
select “ dEL.”
2. (Continuing to hold down the [TAP]
button) Press the [START/STOP]
button to select the ending measure.
The screen indicates the measure
number.
23