Roland TR-606 - Page 7

BASIC
COURSE
(Confd)
Choostnc)
Amplification
The
TR 606 Rhyllirn
Coinposer
may be moni-
tored through
any
conventional
ajnplilication.
but ideal
amplification
will reproduce
its
realistic drum
sounds
faithfully
with a
mini-
mum of
added
distortion
and coloration.
Audio OUTPUT
The
OUTPUT jack on
the
back
panel
of
the
TR-606 presents
the summed output
of ttie
in-
dividual
INSTRUMENT MIX
LEVEL
(f)
con-
trols
as
adjusted by
the master
VOLUME (A)
control to allow very
precise control
over the
TR-606 final output
level and balance.
HEADPHONE
Jack
The TR-606 also
provides
self-contained
ampli-
fication for any
conventional
stereo liead-
pfiones
through a
'A inch stereo phone jack
on
the back
panel. The
HEADPHONE OUTPUT
level is controlled
by the master
VOLUME
control
(A)
in combination
with the
individual
INSTRUMENT
MIX
LEVEL
(g)
controls.
Battery
Eliminator
The
rR-606 is fully
portable, normally
relying
on batteries
for
all internal
hrnciiotis
and to
power the
self-contained
Headphone
amplifier.
To
extend
battery
life,
merely connect
a BOSS
ACA Battery
Eliminator
this socket.
"CAUTION" Don't
connect
any other brand
of Battery
Eliminator, as
this
could
damage
the internal
circuitry of
the
TR 606.
CAUTIONS
(Refer
to
below
leftl
e
Whan
the TR-SOB is
not in use for
long
peri-
ods, remove the
battery to prevent
leakage.
»
If
battery voltage
drops, effect
becomes in-
ferior or
no sound
is produced.
To prevent
that,
replace the
batteries.
•
Be sure
to keep the
batteries
securely
con-
nected,
even while
using the
AC
Adaptor.
'
Even if
AC Adaptor cord
comes out during
performance,
if the
batteries are
connected,
the TR-606 will
continue
to operate.
•If
this
unit is not to
be used for
long
periods
of
time, please
be sure to switch the
power off
and remove the
exausted
batteries, or various
troubles
may be
caused by battery leakage.
Memory
Back-Up
The TR 606
Rhythm
Composer
features
a non-
volatile
memory
which
will
retain Rhythm
Patterns
and Track
compositions when
switch-
ed
'OFF'
and
disconnected from
any
external
power
source.
The
TR-606 relies on
its batteries
for
its back-up
circuit
to protect
these
memories.
Always replace
the
TR-606's batteries
with a
complete
set of
fresh
batteries when tlie
RUN/
BATTERY Indicator
LED ©either flashes
or
fails
to
illuminate
during the normal Run
condition of the
TR-606. If
the
batteries
are
changed
quickly,
within one
minute, the
memory
can
retain the
DATA.
(UM-2)'X4
AC ADAPTOR
(OPTION!
Use BOSS
AC adaptor
for
AC operation.
Use of
a different
adaptor may cause
improper
operation
or
no sound.
BOSS
ACA-120
FOR
i17V
AC
BOSS
ACA-240
FOR
240V AC
BOSS
ACA-220
FOR
220V
AC