Recording Your Performance
37
Data saved on a USB ash drive
The following data can be saved on a USB ash drive.
• Songs recorded on this unit (p. 34)
• Phrases recorded by the looper (p. 38)
• Registration sets (p. 41)
Root folder (top level)
Registration sets
Song les
Looper phrases
Songs recorded on this unit and phrases recorded by the looper are saved in the root folder
of the USB ash drive.
Registration sets saved by Save Registration (p. 41) will be saved in the root folder of the
USB ash drive.
Load Registration (p. 42)/Delete Registration (p. 43) can only load/delete registration
sets that are saved in the root folder of the USB ash drive.
Playing SMF/audio les from a computer
You can copy audio les (WAV, MP3, AIFF) or SMF les from your computer to a USB ash drive, and play them on this unit.
You can copy the SMF/audio les to the root folder of your USB ash drive, or you can create a folder on the USB ash drive and copy the les
into the folder.
Copy to a USB ash drive
Insert USB ash drive
SMF, MP3, WAV, AIFF
MEMO
• Use only single-byte alphanumeric characters in the le names and folder names.
• A maximum of 99 les can be detected in each folder.
SMF/audio les that can be played
SMF
Format
0 or 1
* For an SMF format 1 song that has more than 16 tracks, all of the tracks might not play back
correctly in some cases.
File size
Maximum of approximately 240 KB (this will change somewhat depending on the content of the SMF)
System exclusive Packet size must be 512 byte or less
Audio
WAV/AIFF
Sampling frequency 44.1 kHz
Bit rate 16-bit
MP3
Format MPEG-1 audio layer 3
Sampling frequency 44.1 kHz
Bit rate 32/40/48/56/64/80/96/112/128/160/192/224/256/320 kbps, VBR (Variable Bit Rate)
Introduction Performing Recording Looper Settings
Appendix
To Next Page
Loading...
