Roland V-Drums TD-50 - System Settings and Reset; Formatting an SD Card; Configuring Global TD-50 Settings (Setup); Restoring Factory Default Settings

24
Settings
Formatting an SD Card
Here’s how to format an SD card.
* Before using an SD card for the rst time with the TD-50, you
must format the SD card.
NOTE
When you format an SD card, all data on the SD card is erased.
1. Insert an SD card into the TD-50 (p. 7).
2. Press the [SD CARD] button.
3. Use the PAGE [UP] [DOWN] buttons to access the SD CARD
UTILITY screen.
4. Press the [F3] (FORMAT) button.
The SD CARD FORMAT screen appears.
5. Press the [F5] (FORMAT) button.
A conrmation message appears.
If you decide to cancel, select “CANCEL” and press the [ENTER]
button.
6. Select “OK” and press the [ENTER] button.
The SD card will be formatted.
Settings for the Entire TD-50 (SETUP)
Settings that are common to the entire TD-50, such as the output
destination settings and the footswitch settings, are called “setup”
data.
1. Press the [SETUP] button.
The SETUP MENU screen appears.
2. Use the PAGE [UP] [DOWN] buttons and the function
buttons to select the menu that you want to edit.
Menu Explanation
OUTPUT Specify the output destination of the sounds.
USB AUDIO Make USB audio settings.
OPTION
Make settings for the preview button, the MIX IN
jacks, and the display.
CONTROL Assign functions to the footswitch and pads.
MIDI Make MIDI settings.
AUTO OFF Make AUTO OFF settings (p. 9).
INFO
Check the remaining amount of internal memory and
the program version.
FACTORY RESET Return the TD-50 to its factory settings.
3. Edit the settings of the menu that you selected.
Reference
For details on each menu, refer to “Reference Manual” (PDF).
Restoring the Factory Settings
The “Factory Reset” operation returns all data and settings stored in
the TD-50 to their factory-set condition.
NOTE
When you execute this operation, all data and settings in the TD-50
will be lost. Before you proceed, you should save any important
data and settings to your SD card (p. 23).
1. In the SETUP MENU screen, press the [F1]
(FACTORY RESET) button.
The FACTORY RESET screen appears.
MEMO
If you want all user samples to also be returned to their factory-
set state, use the [–] [+] buttons or the dial to add a check mark
to “Reset with User Sample.” All user samples in user memory are
overwritten by the factory-set data.
2. Press the [F5] (FACTORY RESET) button.
A conrmation message appears.
If you decide to cancel, select “CANCEL” and press the [ENTER] button.
3. Select “OK” and press the [ENTER] button.
The “Factory Reset” operation will be executed.