Roland VersaCamm VS-640i - How to Fold Ribbon Cable to the Head

3-98
2
3
1
Character side
18 +/- 3mm
Character side
18 +/- 3mm
Plain side
90 degree
18 +/- 3mm
Plain side
20 +/- 3mm
18 +/- 3mm
Plain side
20 +/- 3mm
Character side
Character side
A
A
B
C
3-21 HOW TO FOLD RIBBON CABLE TO THE HEAD
These procedures are for the ribbon cables to the Head. The ribbon
cable and the procedure are different from each connector. Refer to
the following list and procedures and fold the ribbon cables.
Connector A : 1000006702 CABLE-CARD,29P1 256L BB HIGH-V
Connector B : 1000006702 CABLE-CARD,29P1 256L BB HIGH-V
Connector C : 1000006703 CABLE-CARD,29P1 276L BBR HIGH-V
There is no difference between left and right direc-
tion.
Place the ribbon cable whose character side faces up.
<Connector A : 1000006702 CABLE-CARD,29P1 256L BB HIGH-V>
<Connector A : 1000006702 CABLE-CARD,29P1 256L BB HIGH-V>
Fold the ribbon cable with 90 degree at the 18 +/-3 mm point
from the left end.
Fold back the ribbon cable at the 20 +/- 3mm point.