Roland VersaCamm VS-640i User Manual

SERVICE NOTES
70240-02
Copyright © 2013 ROLAND DG CORPORATION
Condential
TERMS OF USE
Users of this Service Note shall be deemed to agree with the following Terms of Use.
1. USERS
This Service Note is only for authorized persons with user ID and password issued by Roland DG Corporation.
2. PURPOSE
Authorized persons can use this Service Note only for the purposes of selling and providing to the customers
maintenance service of VS-640i/540i/300i.
3. REUSE
Authorized persons shall not disclose, transfer, rent or distribute this Service Note to, or allow this Service Note
to be used in any manner by, any third party other than authorized persons.
4. REPRODUCTION
Authorized persons shall not copy, change or alter this Service Note without permission of Roland DG
Corporation.
5. EFFECT OF VIOLATION
Regardless of circumstances, we will vigorously respond to any violation hereof, through legal action.

Roland VersaCamm VS-640i Specifications

General

Print Width	64 inches
Print Technology	Inkjet
Ink Type	Eco-Solvent
Media Handling	Roll feed
Connectivity	Ethernet, USB 2.0
Ink Compatibility	Roland Eco-Sol MAX inks
Number of Colors	8 colors
Power Requirements	AC 100-120V, 50/60 Hz

Summary

Terms of Use

Authorized Users and Purpose

Defines authorized users and the permitted purpose of using the service note.

Restrictions on Reuse and Reproduction

Prohibits disclosure, transfer, distribution, copying, or alteration of the service note without permission.

Consequences of Violation

Outlines legal action taken against any violation of the terms.

Structure and Spare Parts

Component Overview Diagram

Provides an exploded view of the machine's main parts with visual identification.

Detailed Parts Lists for Components

Comprehensive lists of main and supplemental parts with part numbers and quantities for each component.

Electrical Section and Wiring Diagrams

Wiring Diagram Overview

Schematic illustrating the interconnections between the main boards and components.

Main Board Circuit Diagrams

Detailed circuit diagrams for the Main Board, showing component layout and connections.

Main Parts Replacement Procedures

Safety Precautions for Parts Replacement

Essential safety instructions including power off and static discharge prevention before handling parts.

Head and Damper Replacement Steps

Detailed steps for replacing the print head and ink dampers, including critical handling precautions.

Motor, Belt, and Board Replacements

Procedures for replacing motors, belts, boards, pumps, and other key mechanical and electrical components.

Machine Adjustment and Calibration Procedures

Service Mode Navigation and Basic Adjustments

Instructions for entering Service Mode, system parameter initialization, and key combinations.

Head and Print Alignment

Guides for head alignment, bias adjustment, flushing position, crop mark, and print/cut position calibration.

Belt and Tension Adjustments

Details procedures for adjusting carriage belt tension, position, and take-up unit operation.

Supplemental Information and Error Handling

Recommended Special Tools

Lists recommended special tools for maintenance and adjustments, including part numbers and purpose.

Sensor Map and Error Code Reference

Diagrams of machine sensors and tables of motor errors and service call codes with causes and actions.

Service Activities and Maintenance

Installation and Setup Procedures

Covers installation checks, unpacking, accessory verification, assembly, software setup, and OnSupport.

Routine Maintenance and Operations

Details basic operations, ink handling, print head care, media handling, and job output management.

Maintenance Checklist and Specifications

Includes a maintenance checklist, consumable replacement cycles, and detailed machine specifications.