Installation
12. Installation
Unpacking
Printer installation
Ink system installation
Take-up unit (TUC-3) installation
Feed adjuster adjustment
Initial ink filling
RIP software installation
1
2
3
4
5
6
7
8
* Check which setting a user takes beforehand, INWARD or OUTWARD.
Referential time: 20 min.
Referential time: 30 min.
Referential time: 25 min.
Referential time: 50 min.
Referential time: 15 min.
Referential time: 30 min.
Referential time: 15 min.
Explanations about how to operate the
machine and how to use RIP software
9
Referential time: Depends on the user’s request
Bidirectional adjustment
Perform this adjustment using the media the user uses.
Referential time: 5 min.
Accumulated time: 20 min.
Accumulated time: 50 min.
Accumulated time: 75 min.
Accumulated time: 125 min.
Accumulated time: 140 min.
Accumulated time: 175 min.
Accumulated time: 190 min.
Accumulated time: 145 min.
*This is for reference only. The amount of time required for each procedure may vary depending on the installation environment.
* The pump does not rotate for 20 minutes in order to let ink flow into sub tanks by its own gravity.
45/47
To Next Page
Loading...
