121
Installing the Wave Expansion Board
Appendices
Next, check to make sure the board has been
installed properly.
1.
Use the procedure in “Turning On the Power” (p. 14) to turn
the power on.
2.
Press [SYSTEM] to make its indicator light.
3.
Press [ CURSOR] a few times to move the cursor to the
parameter group in the upper line of the display.
4.
Turn [VALUE] to choose “INFO.”
5.
Press [CURSOR ] to move the cursor to the parameter at
the lower left of the display.
6.
Turn [VALUE] to choose “XA (XB).” Verify that the name of
the Wave Expansion Board is displayed next to the slot
name.
7.
Press [EXIT] to return to the PLAY screen.
If no board has been installed, or if the wave expansion board is
not being recognized properly, “----------------” appears in the
display.
If “----------------” appears next to the name of the slot in which
the board was installed, it may be that the wave expansion board
is not being recognized properly. Use the procedure in “Turning
Off the Power” (p. 14) to turn the power off, then reinstall the
wave expansion board correctly.
XV-5050_e.book 121 ページ ２００３年６月２７日 金曜日 午後３時１４分
To Next Page
Loading...