Roland XV-5080. - Page 236

236
Error Messages
File Name (Folder, Volume)Format
Error
Situation: A file name has not been assigned.
Action: Assign a file name.
File not Found
Situation: The specified file was not found.
Action: Insert the memory card that contains the
specified file, and try the operation once again.
File Read Error!
Cause 1: The data is damaged, and cannot be loaded.
Action 1: Do not use this file.
Cause 2: A problem has occurred with the connected SCSI
device.
Action 2: Check the connections and power supply of the
SCSI device.
File Write Error!
Cause 1: The media is of a format to which the XV-5080
cannot write.
Action 1: Prepare a media that is of a format to which the
XV-5080 is able to write.
Cause 2: A problem has occurred with the connected SCSI
device.
Action 2: Check the connections and power supply of the
SCSI device.
Folder Level Too Deep!
Cause: You have exceeded the allowable depth to which
folders can be created.
Action: Create the folder at a shallower level of the
folder hierarchy.
Format Completed!
Condition: Formatting has been completed.
Action: Press [F6 (ACCEPT)] to erase the message.
IMPROPER DISK, This Disk is not for
the XV-5080.
Situation: The disk format is not one that can be used by
the XV-5080.
Action: Exchange the disk with one in a format that the
XV-5080 can use, or initialize the disk for use
with the XV-5080.
Illegal Format!
Cause: Since the format of this file is incorrect, it cannot
be loaded.
Action: Do not use this file.
Illegal PCM Wave! Cannot Load This
Wave.
Cause: This file uses a type of compression that the XV-
5080 is unable to read.
Action: Use the device that created the file to convert the
data into an 8 bit or 16 bit wave.
Memory Card Full
Situation: There is insufficient space available on the
memory card to save the data.
Action: Either insert a different memory card, or delete
unnecessary data and try the operation once
again.
Memory Card I/O Error
Situation: It is possible that the memory card has been
scratched or otherwise damaged.
Action: If the memory card has been damaged, do not
use that memory card. If the same error message
appears repeatedly, consult your dealer or a
nearby Roland service station.
Memory Card not Ready
Situation: A memory card is not inserted in the MEMORY
CARD slot.
Action: Turn off the power, and insert a memory card.