5
RolliBot RolliCool COOL100H Portable AC with Heater User Manual
Section 1. Information & Safety Warnings
1.1 – Introduction
This user manual will guide you through the functions and usage of your RolliCool COOL100H
Portable AC with Heater. It is important that you follow all instructions and pay attention to
all notes that appear throughout this manual. Consult this manual before you attempt to use
your RolliCool. If you have questions not answered by this manual or are in need of repair or
non-routine service, contact customer service at 1-844-585-6295. Before contacting customer
service, please have your purchase information ready as this may be needed during the call. This
information may be recorded below.
Date of Purchase:
Place of Purchase:
1.2 – Safety Warnings
When reading this manual, note these icons:
Notes with this icon MUST be read, understood, and obeyed to prevent injury or damage etc.
Notes with this icon include relevant information.
Overall Usage
• Do not insert objects into the product.
• The product is not a toy. Do not leave children unsupervised around the product.
• The product is designed for indoor use only.
• Keep the product upright at all times.
• Do not use the product near any of the following places:
• Near anything ammable
• Direct sunlight
• Damp areas
• Dusty areas
• Do not use wax, thinner, or solvents when cleaning the air conditioner.
• Clean your lters once or more every couple of weeks.
• Do not place any obstacles in front of any air inlet or outlet.
• Do not pull the on the power cords or cables.
• In the event that the product is malfunctioning, shut the power o immediately.
• Switch o the product before cleaning.
• Use only two AAA batteries with the included remote. Do not mix old and new batteries
or batteries from dierent brands.
• Use parts you have received from RolliBot
R
or that have been included in the original
packaging.
• Do not use the product for any purpose other than described in this user manual.
Installation Warnings
• Do not install the product in a sloped setting.
• Do not install the product in direct sunlight.