rollibot RolliCool COOL 100H - 2.4 Remote Overview

9
RolliBot RolliCool COOL100H Portable AC with Heater User Manual
Display Icons
Cool Mode: This icon will light up when
the unit is in cool mode.
Dehumidify Mode: This icon will light up
when the unit is in dehumidify mode.
Fan Mode: This icon will light up when
the unit is in fan mode.
Heat Mode: This icon will light up when
the unit is in heat mode.
Full: This icon will light up when the unit
is full of water.
Timer Mode: This icon will light up when the timer has been programmed.
Sleep Mode: This icon will light up when the unit is in sleep mode.
• Schedulingcanbedoneand/oradjustedviathecontrolpanel,remote,ortheapp.Seethefollowingsectionformore
information about the remote. See Section 4 for information about the app.
• PresstheupanddownbuttonstogetheronthecontrolpaneltoswitchbetweenCelsiusandFahrenheit.
2.4 – Remote Overview
The COOL 100H features a remote with a digital display which may be used with the unit.
Remote Buttons
Timer Button: Press to turn timer mode on or o.
Mode Button: Press to cycle between cool, dehumidify, heat, and
fan modes.
Vent Button: Press to open or close the louvres.
Sleep Button: Press to turn on sleep mode.
Power Button: Press to turn the unit on or o.
Left Button: Press to lower temperature or adjust timer duration.
Right Button: Press to raise temperature or adjust timer duration.
Fan Speed Button: Press to cycle through 3 fan speeds.
°C/°F Button: Press to switch between Celsius and Fahrenheit.
• Avoidpressingtworemotebuttonssimultaneouslyasthismaycausemalfunctions.
• Avoidusingtheremoteinareaswithextremetemperatureuctuations.
• Iftheremotewillnotbeusedforextendedperiodsoftime,removethebattery.
• Theremotecontrol’srangeisapproximately23ft.Useitwithinthisrange.
• Use only two AAA batteries with the included remote. Do not mix old and new batteries or batteries from dierent brands.
Sleep
Fan
Cool
TEMP
Dry
Swing
Heat