32
Inserting the water filter
• Make sure the appliance had been bled correctly before inserting the water filter (please refer to
“Bleeding the system”)!
• As this is an activated carbon filter, the water may take on colour when starting to rinse the filter.
This is normal and will be cleared by rinsing the filter.
• For perfect function, the filter granulate must be completely soaked. Thus, follow all below steps
consecutively.
• The date of exchange can be set on the upper side of the filter (1 – 12).
• Exchange the water filter after 30 litres or after 2 months at the latest.
• Replacement filters are available in specialised trade or from our customer service.
Step 1:
Unpack the filter cartridge.
Step 2:
Prepare filter cartridge.
Steep the filter cartridge for 15
minutes at least in cold tap water.
Step 3:
Remove the water tank
(previously remove the portafilter if
necessary).
Empty residual water.
Step 4:
Position the filter cartridge firmly in
the intended holder at the bottom of
the water tank.
Step 8:
Place a vessel below the outlet of
the hot water/steam nozzle.
Step 5:
Fill the water tank with fresh tap
water up to the “MAX” marking.
Step 6:
Insert the water tank.
Make sure the water tank is inserted
as far as it will go on the gasket.
Step 7:
Position the portafilter without filter
insert at the marking of the brew
head and lock it by turning it to the
right as far as it will go.
Step 9:
Choose the function
“espresso/hot water”.
Step 10:
Switch the appliance on.
The appliance heats up and the pilot
lamp glows red permanently.
When the pilot lamp glows blue, the
appliance is ready for use.
Step 11:
Start hot water supply.
Turn the rotary knob to the right.
Dispense hot water for 1 minute.
Warning: Casing, brew head,
portafilter, filter inserts and hot
water/steam nozzle are getting hot
during use!
To Next Page
Loading...
