38
Step 12: (cleaning/cooling)
Place a vessel below the outlet of
the hot water/steam nozzle.
Step 13: (cleaning/cooling)
For cooling down the system, choose
the function „espresso/hot water“.
The pilot lamp blinks quickly in red.
Step 14: (cleaning/cooling)
Start hot water supply.
Turn the rotary knob to the right.
Dispense hot water for 10 seconds.
The pilot lamp extinguished and the
pilot lamp glows blue permanently.
Step 15: (cleaning/cooling)
Stop hot water supply.
Turn the rotary knob to the left. The
appliance is ready for use.
Step 16:
If the appliance is not needed any
more, switch it off and pull the
mains plug.
Step 17:
Clean the appliance and the
accessories.
Please refer to
“Cleaning and maintenance”
for further information.
Making hot water
• With this appliance, hot water for tea etc. can be made.
• Water out of the hot water/steam nozzle has a temperature of ca. 85 °C.
• Max. 250 ml of hot water can be dispensed.
• Attention: Make sure that the holes in the nozzle are always clean and not clogged.
• Attention: For moving the nozzle, only touch it at the upper plastic part.
Step 2:
Position the portafilter without filter
insert at the marking of the brew
head and lock it by turning it to the
right as far as it will go.
Step 3:
Place a vessel below the outlet of
hot water/steam nozzle.
Warning: Casing, brew head,
portafilter, filter inserts and hot
water/steam nozzle are getting hot
during use!
• Check the water tank
regularly, refill water if
necessary.
• Check the drip pan
regularly, empty it if
necessary.
Step 1:
Prepare the appliance.
To Next Page
