33
Step 12:
Stop hot water supply.
Turn the rotary knob to the left.
Repeat step 11 + 12
3 times.
Step 13:
If the appliance is not needed any
more, switch it off and pull the
mains plug.
• Check the water tank
regularly, refill water if
necessary.
• Check the vessel regularly,
empty it if necessary.
• This process may cause loud
pump noises.
Refilling the water tank
• Avoid that the water tank is drained completely during use! We recommend checking the water level
prior to each use and refilling water up to the “MAX” marking.
• The appliance has an electronic water level control. If water is missing in the water tank, the pilot
lamp will blink in short intervals in blue and the pump will stop.
• For refilling the water tank, there is no need to take out the water filter.
• After refilling the water tank, bleed the system if necessary.
Warning: Casing, brew head,
portafilter, filter inserts and hot
water/steam nozzle are getting hot
during use!
Step 2:
Fill the water tank with fresh tap
water.
Observe the “MAX” marking!
Step 3:
Insert the water tank.
Make sure the water tank is inserted
as far as it will go on the gasket.
Step 4: (bleeding)
Position the portafilter without filter
insert at the marking of the brew
head and lock it by turning it to the
right as far as it will go.
Step 5: (bleeding)
Place a vessel below the outlet of
the hot water/steam nozzle.
Step 6: (bleeding)
Choose the function
“espresso/hot water”.
Step 7: (bleeding)
Switch the appliance on.
The appliance heats up and the pilot
lamp glows red permanently.
When the pilot lamp glows blue, the
appliance is ready for use.
Step 1:
Remove the water tank
(previously remove the portafilter if
necessary).
Empty residual water.
To Next Page
Loading...
Need help?
General
