Room essentials 417087 - Step 6: Connecting Backs to Rear Leg

11
step 6.
417087
Insert three METAL PINS (1R) into the holes shown in the RIGHT REAR LEG (H).
Fasten the BACKS (E2) to the RIGHT REAR LEG (H). Tighten three HIDDEN CAMS.
NOTE: Be sure the METAL PINS (1R) in the LEG (H) insert into the holes in the ends of the BACKS (E2).
Insert three METAL PINS (1R) into the smaller holes in the BACKS (E2).
(1R) x 6
metal pin
1R
Surface
with
HIDDEN
CAMS
Edge closer
to HIDDEN
CAMS
1R
E2
E2
E2
Edge closer
to HIDDEN
CAMS
Edge closer
to HIDDEN
CAMS
H
Surface
with
HIDDEN
CAMS
Surface
with
HIDDEN
CAMS
Serious or fatal crushing injuries can occur
from furniture tip-over. To help prevent
tip-over:
• Install tip-over restraint provided.
• Place heaviest items on the lowest surfaces as
far back from the front edge as possible.
• Unless specifi cally designed to accommodate,
do not set TVs or other heavy objects on top of
this item.
• Never allow children to hang on drawers, doors
or shelves.
Use of tip-over restraints may only reduce, but
not eliminate, the risk of tip-over.
This is a permanent label. Do not attempt to remove!
WARNING