Wireless LAN PCI Card RNX-N300X User Manual
33
b/g/n mix; Otherwise system default is 802.11 b/g mix (802.11 b/g/n mix selection item
only exists for b/g/n adapter).
3. Country Region Code: eight countries to choose. Country channel list:
Classification Range
0: FCC (Canada) CH1 ~ CH11
1: ETSI CH1 ~ CH13
2: SPAIN CH10 ~ CH11
3: FRANCE CH10 ~ CH13
4: MKK CH14 ~ CH14
5: MKKI (TELEC) CH1 ~ CH14
6: ISRAEL CH3 ~ CH9
7: ISRAEL CH5 ~ CH13
4. Wireless Protection: Auto, on, and off. System default is auto.
a. Auto: STA will dynamically change as AP announcement.
b. On: Always send frame with protection.
c. Off: Always send frame without protection.
5. Beacon (ms): The time between two beacons. System default is 100 ms.
6. TX Power: Manually force the AP transmits power. System default is 100%.
7. TX Rate: Manually force the Transmit using selected rate. Default is auto.
8. Idle Time: Manually force the Idle Time using selected value. Default is 300.
9. Channel: Manually force the AP using the channel. System default is channel 1.
10. Use Mac Address: Use MAC address of used wireless card to be AP name. System
default is APX (X is last number of Mac Address).
11. Security Setting: Authentication mode and encryption algorithm used within the AP.
System default is no authentication and encryption.
12. No forwarding among wireless clients: No beacon among wireless client, clients can
share information each other. System default is no forwarding.
13. Hide SSID: Prevent this AP from recognized in wireless network. This is disabled as
default.
14. Allow BW40 MHz: Allow BW40 MHz capability.
15. Default: Use system default value.
16. Apply: Apply the above changes.
To Next Page
