Wireless LAN PCI Card RNX-N300X User Manual
32
Chapter 4 AP mode management guide
This adapter can be configured as AP mode. In order to set this adapter as an AP, please
right click the
icon on system tray and select “Switch to AP mode”. Please refer to the
following introduction to information about this AP-mode utility.
Note: In Windows® XP, it provides WPA support at hotfix Q815485 However, you have to
make sure that hotfix Q815485 (require XP SP1 installed) has been installed in your system
before you can start using WPA features. You can check the installation of hotfix in
add/remove software page under control panel.
4.1 Configuration
This page provides overall configuration to this adapter. Please find the following items for
identification to each field.
1. SSID: AP name of user type. User also can select [Use Mac Address] to display it.
2. Wireless Mode: Select wireless mode. 802.11 b/g mix, 802.11b only, 802.11g only, 802.11
b/g/n mix mode are supported. When wireless card is 802.11n, system default is 802.11
To Next Page
Loading...
Need help?
General
