Rosslare AC-Q41SB User Manual

Programming
54 AC-Q4x Series Installation and Programming Manual
5.16 Changing PIN Code Length/Factory Default
Settings
You must be very careful before using this command! Changing
the PIN code length also erases the entire memory contents,
including all user and special codes, and returns all codes to
their factory default settings.
To change PIN code length:
1. Enter Programming mode.
2. Select the desired PIN code length as follows:
 00 – Returns to factory defaults and sets a 4-digit code
 05 – Returns to factory defaults and sets a 5-digit code
 06 – Returns to factory defaults and sets a 6-digit code
 08 – Returns to factory defaults and sets a 4-8 digit code
When choosing the 4–8 option, please note that you should
either enter zeros before the code, or press pound at the end
(for example if your code is 12345, enter either 00012345 or
12345#).
Both LEDs flash red.
3. Enter your 4-digit Programming code.
If the Programming code is valid, all memory is erased. You hear
three beeps and the controller returns to Normal mode.
If the Programming code is invalid, you hear a long beep and the
controller returns to Normal mode without erasing the memory
contents.
Red Red
Green

Rosslare AC-Q41SB Specifications

General

Brand	Rosslare
Model	AC-Q41SB
Category	Keypad
Language	English