Page 14
07/04
Normal, Secure, & Master Users
The AC-S43 accepts up to 500 users and provides entry via the use
of PIN codes. Each user is provided with two code memory slots,
Memory Slot 1 (Primary Code) and Memory Slot 2 (Secondary
Code).
The way in which the two memory slots are programmed
determines a users access level and also determines the way in
which the AC-S43 grants access in its three Modes of Operation.
There are three user levels:
Normal User
A Normal User only has a Primary Code and is only
granted access when the AC-S43 is in Normal or
Bypass Mode.
Secure User
A Secure User must have a Primary and Secondary
Code programmed, the two codes must not be the
same. The Secure User can gain access when the
AC-S43 is in any of its three Modes of Operation. In
Normal Mode the Secure User must use their
Primary Code to gain entry. In Secure Mode the
Secure User must first present their Primary Code
and then their Secondary Code in order to gain
entry.
Master User
A Master User must have both Primary and
Secondary Codes programmed with the same
Proximity Card or PIN code. The Master User can
gain access during any Mode of Operation by
presenting their PIN code to the controller.
AC-S43
07/04
Page 15
AC-S43
Modes of Operation
!
The AC-S43 has 3 Modes of Operation:
1) Normal Mode.
Mode LED is green
Normal Mode is the default mode. In Normal Mode the door is
locked until a Primary Code is presented to the controller. The
controller can only be programmed in Normal Mode.
2) Bypass Mode.
!
Mode LED is orange
In Bypass Mode, access to the premises is dependent on
whether the controller's Lock Strike Relay is programmed for Fail
Safe Operation or Fail Secure Operation.
When the Lock Strike Relay is programmed for
Fail Secure Operation, the door is locked until the Star
button is pressed.
When the Lock Strike Relay is programmed for
Fail Safe Operation, the door is constantly unlocked.
In case of power failure, for security reasons when power is
restored the controller will be in Normal Mode.
3) Secure Mode.
!
Mode LED is red
Only Secure and Master Users can access the premises during
the Secured Mode.
Mode Door
GREEN
Mode Door
ORANGE
Mode Door
RED
A Secure User must enter their Primary and
Secondary Codes to gain entry. After entering their Primary
code the Door LED will flash green for 10 seconds, during
which the Secondary Code must be entered. A Master User
only needs to present their Proximity Cord or PIN code once to
gain entry.
To Next Page
Loading...
Need help?
General
