Rosslare AY-B86x0 Series User Manual

3
4. Instructions for Placing Finger
 Correct Method: Straighten your finger and then place it on the sensor, ensuring the finger is down flat and covers the entire sensor window.
Always place finger in the center of the
sensor.
Make sure you cover the entire sensor surface
with as much of your finger as possible.
 Incorrect Method:
DO NOT move your finger
before the backlights of
the sensor turns off.
DO NOT place finger
away from the center
of the sensor window
DO NOT place finger at
an angle.
DO NOT take off finger
during the fingerprint
verification process.
DO NOT use just
your fingertip.
DO NOT slide your finger
during the fingerprint
verification process.
5. Technical Specifications
Fingerprint Sensor 500 DPI Optical Sensor
RFID Card Reader AY-B8620 – 125 kHz
AY-B8650 – 13.56 MHz
User Capacity 7000
Fingerprint Capacity 7000
Card Capacity 7000
Log Capacity 100,000
Verification Speed < 1 Second (1:N)
Card Read Range 20 to 80 mm (0.8 to 3.1 in.)
Identification Mode Fingerprint/Card
Network Port TCP/IP
Wiegand Protocol Wiegand 26-Bit
Voice and Interface Multi-color LEDs and buzzer
Operating Voltage 12 VDC
Work Current 150 mA
Operating Temperature Range -20°C to 60°C
Humidity Range 10% to 95% (non-condensing)
Size (W x H x D) 50 x 124 x 34.5 mm (1.97 x 4.9 x 1.4 in.)
Certificate FCC, CE, RoHS
Figure 12: Reader Layout
6. Usage Notice
 Do not scratch the surface of the optical fingerprint sensor with
any sharp object such as a small knife or a pen.
 Humidity, dust, and direct light can affect the terminal’s
performance.
 Do not clean the surface of the optical fingerprint sensor with
organic material such as alcohol or gasoline.
 To clean the surface, apply a piece of one-sided adhesive tape to
the sensor and then remove.

Rosslare AY-B86x0 Series Specifications

General

Brand	Rosslare
Model	AY-B86x0 Series
Category	Card Reader
Language	English