026 GB/USKey to Symbols
Class II: A luminaire in which protection against
electric shock relies not just on basic insulation, but
where additional safety precautions such as double
insulation or reinforced insulation are provided.
Class III: A luminaire in which protection against elec-
tric shock relies on supply at safety extra-low voltage
(SELV) and in which voltages higher than those of
SELV are not generated.
A luminaire designed for direct mounting on normally
inflammable surfaces. Maximum temperature at the
base of the installation surface Tmax=90°C.
Protection level IP 20. Protection is effective against
contact with solid bodies of Ø 12 mm. No protection
is provided against rain. No indications are provided
on the luminaire.
Methods for replacing the supply cable. Method X: the
supply cable can be replaced easily by the user. Method
Y: the supply cable must be replaced by the manufactur-
er or by qualified personnel. Method Z: the supply cable
cannot be replaced without irreparable damage to the
device. For the type of cable please contact the supplier
or the service centre.
Laser Radiation. Do not view with optical instruments such
as lenses, binoculars or telescopes. Class 1M LED product.
Attention. The product cannot be disposed of as
unsorted municipal waste. It must be collected separately
to prevent negative environmental impact. In accordance
with the procedures of Directive 2002/96 and relevant
national laws and regulations adopted pursuant to this
Directive, on the disposal of waste, at the end of the life
cycle of the product, any violation is sanctioned by law.
Please inform yourself about the local, separate collection
system for electrical and electronic products.
To Next Page
Loading...