Rotary 100 Series - 7. Operating Instructions; 7.1 Pre-Operation Checks and Setup; 7.2 Vehicle Loading Procedures; 7.3 Raising the Lift Safely

12
Fig. 12
Note: The following illustrations show the installation of the
power units. Although not shown you may want to wire all
motors before lowering them into the front and rear housings.
Step 13: Lowering The Power Units Into Moveable Post Housings.
A.) Lower power units and tanks into moveable post housings and
onto the power unit brackets just behind the position sensor, Fig.
12.
Several types of motors are used
on the hydraulic tank assemblies. Adjustments may be
needed to the check valve if it rubs against the power unit.
The check valve should only be rotated just
enough to keep it from rubbing against the
power unit. If it’
s rotated too much it may
interfere with the drive chain from the drive in
the moveable housing. Interference issues
should be checked during the installation of
the drive chain.
IMPORTANT
Power Unit
Junction
Box
Check Valve
Rotate 45°
T
owards Housing
Power Unit Bracket
Lower Power Unit
Into Front Housing
Keep Check Valve Assembly
From Getting Damaged
While Power Unit Is
Being Lowered Into
Front Housing.
CAUTION
Install Elbow(#16 JIC) Before Lowering Power
Unit Into Housing. Elbow For Hydraulic Hose
Faces Post.
Position Sensor
And Adapter Bracket