Rotary 100 Series - 6. Installation Guide and Requirements; 6.1 Installation Warnings and Setup; 6.2 Installation Options and Vehicle Placement

11
Brackets
Located
Here
Position Sensor
And Bracket
String On
Position Sensor
Faces Post
Bracket On Position Sensor
Slides Onto Here
Post
SPOOL LOCKING SCREW
REMOVE PRIOR TO
OPERATION
Remember To Remove
The Spool Locking Screw
Before Trying To Pull String
Out Of Position Sensor.
Never Let String Snap Back To Position Sensor
IMPORTANT
IMPORTANT
Position Sensor
Adapter Bracket
(4) 1/4-20NC x 1" HHCS
(4) 1/4"-20NC
Nylon Insert Lock Nut
Plug-In
Position Sensor
Position Sensor Cover
Mounts Between Bolts
And Position Sensor
Adapter Bracket
SPOOL LOCKING SCREW
REMOVE PRIOR TO
OPERATION
Fig. 10
Fig. 11
Step 11: Mounting The Position Sensors To Position Sensor
Adapter Brackets:
A.) Mount the position sensor to the position sensor adapter
bracket, Fig. 10, with 1/4"-20NC x 1" HHCS and nylon insert lock
nuts.
NOTE: Notice the orientation of the position sensor to the
bracket, Fig. 10. Plug-In on position sensor will face downward.
Step 12: Placing The Position Sensors And Brackets Onto The
Power Unit Brackets In Moveable Post
Housings:
A.) Attach data cable to horizontal string pot then lower the
position sensors and brackets into moveable post housings and
onto the power unit bracket, Fig. 11.
NOTE: The string on the potentiometer faces the post.