Rotary E Series - Page 4

4
00/00/00 00:00
FF
1
O
N
Slave Control Panel Only Runs The
Lift - You Can Not Select Any Menus
From The Slave Side.
5 Menu Selection / Lower To Locks
FF
1
O
N
2 Raise Lift
4 Mode Button
5 Lower To Locks
3 Lower Lift
Touch Pad
Touch Pad
1 Disconnect
Switch
Tab Can Be
Pulled Out
Of Switch To
Lock Disconnect
In OFF Position
Lift Controls For:
E Series Lifts
1 Turning disconnect switches provides electircity to motor.
Note: Both disconnect switches must be "ON" to provide
electricity to motor.
2 Raises lift.
3 Lowers lift.
4 Resets the lift.
5 Lowers lift to locking latches.
Note: Press to raise lift off of locking latches then press
to lower lift.
Lift Controls For:
i Series Lifts
1 Turning disconnect switch provides electircity to motor.
Note: Both disconnect switches must be "ON" to provide
electricity to motor.
2 Raises lift and scrolls up through menu selections.
3 Lowers lift and scrolls down through menu selections.
4 Toggles operator between menu selection and lift operation.
5 Lowers lift to locking latches.
Note: Press to raise lift off of locking latches then press
to lower lift.
1 Disconnect
Switch
Tab Can Be
Pulled Out
Of Switch To
Lock Disconnect
In OFF Position
2 Raise Lift / Scroll Up
3 Lower Lift / Scroll Down
4 Mode Button
Fig.1a