Rotary SM14 - Safety Instructions; Operator and Bystander Restrictions; Vehicle Loading Safety; Lift Operation Safety

3
5. Runway and Wheel Stop Attachment:
With the openings in the yoke tube side lined up with the left
runway ends, align the two (2) holes in the top of the front yoke
tube with the slots in the runway end plates and the holes in the
front wheel stops. Bolt runway to the yoke using four M12-30
hex flange bolts, Fig. 4.
4. Runway and Yoke Tube Assembly:
A. Determine direction of approach in bay.
B. Position left runway in bay with hydraulic cylinder hose
connection to front of bay. Cables and sheaves are pre-
assembled in runway. Runway needs to be up off floor so
shipping restraints can be removed from cable ends, air and
hydraulic lines, and cylinder rod. Pull cable ends, air, and
hydraulic lines out for assembly. Make sure cables are in
proper sheave grooves, Fig. 3.
C. Position front and rear yokes at respective ends of runway,
Fig. 1. The opening in the side of the yokes should be lined up
with the cable sheaves in the runway ends. Feed cable ends
through yoke openings, Fig. 4 . Do not assemble sheaves in
yoke ends at this time.
IMPORTANT
Be sure cables are not crossed inside yoke.
Right Front
Cable (#1)
Right Rear
Cable (#3)
REAR
Left Front
Cable (#2)
FRONT
Right Front
Cable (#1)
Left Rear
Cable (#4)
Left Front
Cable (#2)
CABLES IN PROPER SHEAVE GROOVES
FEED CABLE ENDS THROUGH YOKE OPENINGS
Front Yoke
Cable
Right Runway
Front Yoke
Cable
Runway
Sheave
Left Runway
M12-30 hex flange
Whiz-Lock
M12-30 hex flange Whiz-Lock
Front Wheel Stop
Fig. 3
Fig. 4