W
Wanda CastilloAug 5, 2025
What to do if the runways lower unevenly on my Rotary SM40-47 Lifting Systems?
- Jjerry76Aug 5, 2025
If the runways of your Rotary Lifting Systems lower unevenly, first ensure that all cables are properly tensioned after moving the lift up slightly. Then, check for obstructions under the lift and remove them. Adjustments may be needed, which requires fully lowering the lift. Also, verify correct operation of the lift. If the height difference exceeds 50 mm and these steps don't resolve the issue, consult Chapter 6 for authorized lowering procedures or Chapter 9 for maintenance and repair.