Rotary SPOA7 Series - User Manual

SPOA10NB, SPOA10, SPO10, SPOA7
(500, 700, and 800 Series Lifts)
SPOA7 Capacity 7,000 lbs. (3,175 kg.)
SPOA10NB, SPOA10, SPO10 Capacity 10,000 lbs. (4,536 kg.)
Español Página 20
Le Français La page 40
I
N
S
T
A
L
L
A
T
I
O
N
I
N
S
T
R
U
C
T
I
O
N
S
© June 2019 by Vehicle Service Group. All rights reserved. CO10473
I
N
S
T
A
L
L
A
T
I
O
N
I
N
S
T
R
U
C
T
I
O
N
S
LP20314
IN20384
Rev. BE 6/11/2019
OPERATING CONDITIONS
Lift is not intended for outdoor use
and has an operating ambient temperature
range of
41°-104°F (5°-40°C)
IMPORTANT
Reference ANSI/ALI ALIS,
Safety Requirements for
Installation and Service of Automotive Lifts
before installing lift.

Rotary SPOA7 Series Specifications

General

Capacity	7, 000 lbs
Voltage	208-230V
Power Source	Electric
Drive-Thru Clearance	96 inches
Operation	Hydraulic

Summary

Rotary Lift Installation Instructions

Safety Requirements

Reference ANSI/ALI ALIS, Safety Requirements for Installation and Service of Automotive Lifts before installing lift.

Initial Lift Installation Steps

Lift Location and Height

Column Extensions and Mounting

Concrete and Anchoring

Anchoring Procedure

Drill holes, drive anchors, and tighten to specified torque values for non-seismic lifts.

Anchor Installation Reference

Table detailing anchor types, dimensions, torque, and concrete requirements.

Anchoring and Overhead Assembly

Non-Seismic Anchoring Details

Overhead Assembly Installation

Instructions for attaching the overhead assembly to the mounting brackets and switch box.

Power Unit and Hose Installation

Power Unit Mounting

Mount the power unit to the column bracket using flanged locking HHCS and nuts.

Hose Installation and Fittings

Locking Latch Cable Installation

Latch Cable Routing

Route the latch cable through columns, guides, and sheaves to the latch mechanism.

Latch Cable Adjustment

Single Phase Electrical Connections

Single Phase Wiring Diagram

Diagram illustrating wiring connections for a single phase power unit.

Single Phase Motor Data

Three Phase Electrical Connections

Three Phase Wiring Options

Diagrams for three phase power unit wiring, showing different pin layouts.

Three Phase Motor Data

Three Phase Control Box Installation

Control Box Mounting

Attach the mounting bracket and control box to the column using specified hardware.

Control Box Wiring

Fluid and Arm Installation

Hydraulic Oil Filling and Bleeding

Arm and Restraint Installation

Final Installation Steps and Checks

Adapter Assembly and Bumpers

Latch and Equalizer Cable Adjustments

Testing and Operation Verification

Perform pressure tests and verify all lift functions and clearances.