17
ARM STOP
ARM PIN
ARM
ARM STOP IS LOCATED IN THE YOKE
TUBE CLOSEST TO THE POWER UNIT.
POSITION ARM STOP AS SHOWN.
Fig. 21
Fig. 22
17. Arm Restraints & Superstructure:
Before installing arms, confirm arm pins and arm pin holes
are greased with anti-sieze. Slide arm onto yoke and
install the arm pins. (Recommended 2 people for install).
Note: Install Arm Stop only in the yoke tube closest to the
Power Unit as shown in Fig. 21.
(12) 3/8-16NC x 1-1/2" lg. HHCS
(12) 3/8" Spring Lockwashers
Restraint Gear
Rounded
Edge Up
"TOP" will be
marked on top side
of restraint gear
Arm Clevis
Install arm restraint gear over pin and into the slot in the
arm pin ensuring the side of the gear marked TOP is facing
upward. Fig. 22.
To Next Page
Loading...
