Rotec ERGO-DigiStick - English; Warranty Terms

25
Contents
Warranty Terms …………………………………………………….…….……….……………….… 25
Connecng the Joysck to the Power Source …………...…………….………………... 26
How to Place the Joysck ……………………….…………………………………..…………….. 26
Used Together with a Forest Crane Valve (BC60/8) .……..…………….…..……... 27
Used Together with a Front Loader Valve (BC60/2) ……..……...………...………... 28
How to Adjust the Start and Maximum Speed ……...…………..….………….……….. 29
How to Recall the Factory Sengs …………………....……………………………….…...… 30
How to Choose the Ramps …………………………………………………….………… …..…… 31
How to Adjust the Dead Bands …………………………...…………………………..… ….…. 32
Operang addional solenoid valves by using a rele …………………………………. 33
Meaning of the LED indicaons …..…...…………………………………………..…… ….… 34
Informaon about the ERGO-DigiSck ………………………………………..………… ..… 35
Warranty Terms
The warranty time for the mechanical parts in the ERGO-DigiStick joystick is one year. The
electronic components have a limited warranty of one year since the producer of the
joystick is not able to control where the joystick is installed. The warranty is not valid if the
problem originates from the users broken or poorly working electrical system in the
working machine. Inside the joystick there are built-in protection-components intended to
protect the PCB against a limited amount high voltage spikes and like. The user must
be sure that there are no problems in the electrical system which will give often
recurring high voltage spikes because these high voltage spikes will sooner or
later destroy the protection components and when this happens the PCB will be
destroyed. If the red LED light is flashing continuously, even after the power supply has
been switched off and on again, it indicates that the PCB (circuit board) has been
destroyed because of often recurring high voltage spikes. In this case the warranty is not
valid. Before installing a new PCB, it is important that the problem in the electrical system
is fixed; otherwise there is a great risk that the new PCB also will be destroyed.
It is very important to carefully follow the instructions which are given in this manual to
avoid the problems described above. Especially important are the instructions about
power supply, the power switch and the usage of the power switch when the working
machine is started.