Rotec ERGO-DigiStick - How to Adjust the Start and Maximum Speed

29
How to adjust the start and maximum speed
Follow the instrucons below for adjusng start and maximum speeds (currents) for
one ore more joysckdirecons:
1. Put the joysck in programming mode
 Start the tractor and put the hydraulic pressure on
 Switch off electric power from the joysticks
 Press and hold the A-switch (the swith with a cavity)
 Turn the power on, wait for 5 seconds until the red LED light appears (this
indicates that the joystick is now in programming mode)
 Release the A-switch
 Now, choose which function (direction of the lever/roll) you want to adjust
and do steps 2 and 3. If you after this want to adjust another function do
steps 2 and 3 again for the new direction. When you have adjusted all the
desired functions (one or several) you can go to step 4 to exit the
programming mode and start to use the joystick
2. Dene the desired start speed of the selected funcon
 Move the lever/roll to the desired direction until the desired start speed is
reached and register the start current by pressing the A-switch (max 1
second, in this step the LED-light will NOT flash)
 Let the lever/roll go back to the centre position (LED light flashes now and
indicates that the information is stored in the memory)
3. Dene the desired maximum speed for the funcon
 Move the lever/roll to the same direction as in step 2 until the
desired maximum speed is reached and select this current by
pressing the A-switch (max 1 second, in this step the LED-light will
NOT flash)
 Let the lever/roll go back to the centre position (LED light flashes now and
indicates that the information is stored in the memory)
4. Exit the programming mode
 Hold the A-switch pressed until LED light indicates that the programming
mode is ended. The joystick is now ready for use