Rotec ERGO-DigiStick - How to Recall the Factory Settings

30
How to Recall the Factory Sengs
A fast recall of the factory sengs is done with the roll. The recall does not eect
the dead bands (see page 32 for further informaon) or the potenometre limits.
Fast Recall of the Factory Sengs with the Roll
1. Switch o electric power from the joysck
2. Either push or pull the roll the roll to its maximum posion
3. With the roll in one of it maximum posions: switch on the electrical
power to the joysck (the LED light will now be alight for 1 secound)
4. Let the roll go back to its original posion
5. The joysck is now ready to use
Aer recalling the factory sengs, the start current is relavely low (ensuring that
all funcons will have a smoth start) and the max current is very high (ensuring
that all funcons certainly get enough current to reach full strength/movement
speed). Because of this wide current range (low minimum current and high
maximum), there is probably a need to tune up individual movements for the best
driving comfort (see page 29).