Rotec ERGO-DigiStick - Used Together with a Forest Crane Valve (BC60;8)

27
3
4
2
1
C
D
A
B
4
3
1
2
C
B
A
D
LEFT HAND JOYSTICK
1 Second boom down
2 Second boom up
3 Crane turnig to the right
4 Crane turning to the le
A Le stabilator down
B Le stabilator up
C Extension tube in
D Extension tube out
RIGHT HAND JOYSTICK
1 Main boom down
2 Main boom up
3 Rotator turns counterclockwise
4 Rotator turns clockwise
A Right stabilator up
B Right stabilator down
C Grapple closing
D Grapple opening
ERGO-DigiSticks operating a Forest Crane Valve
How to Connect the Joysck to the Valve and How the Joysck
Movements Corresponds with the Steering Cable Markings
In the picture below the direcons of the joyscks are marked with [1, 2, 3, 4].
The direcon of the rolls are marked with [C, D] and the buons with [A, B].
Under the picture you nd the forest crane funcons which the dierent
movements corresponds to. The 8 connectors of the steering cable are marked
[1, 2, 3, 4, A, B, C, D] and should be connected to the solenoids so that they
corresponds to the funcons below.
The Steering Cables are Connected to the Solenoids as Follows: