Need help?Do you have a question about the Rotel RA-611 and is the answer not in the manual?
General| Frequency response | 10Hz to 50kHz |
|---|---|
| Damping factor | 50 |
| Input sensitivity | 2.5mV (MM), 150mV (line) |
| Speaker load impedance | 4Ω to 16Ω |
| Power output | 30 watts per channel into 8Ω (stereo) |
| Signal to noise ratio | 75dB (MM), 85dB (line) |
Details on connecting two sets of speakers securely and ensuring correct phasing.
Guides for connecting record players, tuners, and auxiliary sources via RCA and DIN.
Instructions for connecting tape decks and separating amplifier sections via jumpers.
Information on AC outlets, voltage selection, and power supply setup.
Ensures correct voltage setting and safe connection to the mains power.
Information on AC and DC fuses, their ratings, and replacement procedures.
Identifies key controls like volume, tone, input selector, and switches.
Explains volume, balance, bass, and treble controls for sound adjustment.
Guides on using input selector and speaker controls for different sources.
Details on tone, loudness, muting, and mode switches for sound shaping.
Explains high/low filters, power switch, and headphone usage.
Guides for initial checks, fuse inspection, and speaker phasing verification.
Instructions for selecting inputs and modes for tuners and record players.
Details on playing back tapes using AUX or TAPE MONITOR inputs.
Guides for recording off-air, discs, or dubbing between tape recorders.
Advice on unit placement, grounding, and troubleshooting hum issues.
Details on total music power, continuous power, and harmonic distortion.
Information on frequency response, power bandwidth, input sensitivity, and impedance.
Details on output voltage, harmonic distortion, and hum/noise levels.
Specifies input sensitivity, impedance for various inputs, and phono overload.
Information on phono equalizer type, RIAA curve, and filter characteristics.
To Next Page
