To Next PageTo Next Page
Need help?Do you have a question about the Rotel RA-1520 and is the answer not in the manual?
General| Output level | 1000 mV |
|---|---|
| Damping factor | 150 |
| Amplifier class | - |
| Frequency range | 20 - 20000 Hz |
| Output impedance | 470 Ω |
| Input sensitivity | 160 mV |
| Audio output channels | 2.0 channels |
| Peak power per channel | - W |
| Signal-to-Noise Ratio (SNR) | 95 dB |
| Total Harmonic Distortion (THD) | 0.03 % |
| RMS power output per channel (8 Ohm) | 60 W |
| Purpose | Home |
| Product color | Silver |
| Connectivity technology | Wired |
| AC input voltage | 230 V |
| AC input frequency | 50 Hz |
| Power consumption (typical) | 300 W |
Weight and Dimensions| Depth | 364 mm |
|---|---|
| Width | 432 mm |
| Height | 92 mm |
| Weight | 7800 g |
Warning about the risk of electric shock, advising against opening the unit.
Essential setup steps, safety precautions, and system configuration guidance.
Guidelines for optimal unit placement, clearance, and ventilation to prevent overheating.
Advice on routing and separating power, digital, and audio cables to minimize noise.
Instructions for using the remote control, including sensor placement, batteries, and external connections.
Guidance on speaker impedance requirements and selecting appropriate speaker wire.
Ensuring correct polarity and phasing for speaker connections and wiring procedures.
Connecting turntables and other line-level audio sources to the amplifier.
Connecting tape recorders and portable media players via specific input jacks.
Information on using the preamp outputs to connect to external power amplifiers.
How to connect the unit to AC power and operate the power button and indicator.
Explanation of the 12V trigger connection for system integration.
How to adjust volume and left-to-right sound balance using controls or remote.
Adjusting bass/treble, bypassing tone controls, and selecting audio sources.
How to select recording sources and temporarily mute the audio output.
Connecting headphones and selecting active speaker configurations.
Steps to resolve issues with the power indicator not lighting or no sound output.
What to do if the protection indicator is lit or if the unit requires fuse replacement.
Resolving remote control conflicts and resetting IR codes for proper operation.
