Rotel RB991 - Page 6

SPECIFICATIONS:
Continuous Power Oulpul
i2Q-m kHz,^O.Q3^,6
ohms) ZOO watts,''oh,
{2CT20 kHz. S 4
ohms)
300 watts>''ch.
Total Harmonic Distorimn
[20 Hz^20 kHz. 8 ohms)
Intermodulation Drstortion
(60 Hr 7 kHz, AH)
<0.03%
Frequency Response
^10-100,000 Hz, ±1
Damping Factor
[20^20,000 Hz, B chms)
>500
Speaker Impedance
4-16 ohms
Signal to Noise Ratio
{IHF A network)
120 dB
InpLTt ImpHKaance/Sansitivity
(RCA Inputs)
33 k OhmaM.O volt
[XLR Inputs)
33k Ohm&'T.Ovol!
Power Requirements
115 Volts, 60 Hz or
230 Volts, 50 Hz
Power Consumption
550 Watts
Dimensions (W. H, D)
440 J! 127x335 mm
17.35x4.76x15.16"
Weigh! {net)
16.7 kg., 36 J4 lb.
All gp^cificalions are accural® at the time of prIntinQ. Rotel leserves the ri^ht to make impnovemeinte
without notice.
SYSIE.MTR Q.UBLESHOOTING HINTS
IS THE AC CO HD CONNECTED TO A SWITCHED AC OUTLET?
IS TME SWITCHED AC OUTLET TURNED ON?
CHECK THE POWER FUSE FOR THE AC OUTLET,
NtLS.QUND CORRECT INPUT SELECTED? IS THE AMPLIFIER
TURNED ON? IS THE SOURCE COMPONENT TURNED ON?
IS THE SOURCE COMPONENT CONNECTED PROPERLY?
are THE SPEAKER WIRES CONNECTED PROPERLY?
NQBAS_S
PQQFtlRACKlNq
(CD PLAYER)
IS THE SUBWOOFER AMPLIFIER TURNED ON?
IS THE POVi/ERED SUBWOOFER TURNED ON?
ARE THE-WOOFERS" fN YOUR SPEAKERS DAMAGED?
ARE THE SPEAKERS WIRED CORRECTLY FOR PHASER
IS THE DISC DIRTY OR SCRATCHED? IS THE DISC
SEVERELY WARPED? IS THE DISC SEMI-TRANSPARENT OR
POORLY MADE WITH VISIBLE -PIN' HOLES? IS THE CD
CRACKED?
POOR. PUlLSilUND A R E THE HEADS DIRTY? HEADS MAGNETIZED FROM LONG
WOW_&JiLUHlR USAGE WITHOUT DEMAGNETIZING? ARE THE FINCH
(TAPE DECK) ROLLER AND THE CAPSTAN DIRTY? CLEAN WITH PURE
ALCOHOLV 77P COTTON BUDS OH A TAPE DECK
CLEANING KIT DEMAGNETIZE THE HEADS WITH A HAND
HELD DEMAGNETIZER. DO NOT USE ABRASIVE DRY
CLEANERS!
5