Roxell Minimax Line - Page 3

ROXELL - 001 - 2112
MINIMAX LINE - TABLE OF CONTENTS
OPTION : CENTRAL WINCH W/GEARBOX -- MOTOR OPERATED II--23......................
OPTION : CONTROL PANEL FOR CENTRAL WINCH II--24.................................
OPTION : CONTROL PANEL FOR CENTRAL WINCH II--25.................................
CUT--OFF SWITCH II--26..............................................................
CONTROL PANEL WITH TIME CLOCK II--27.............................................
BOX W/COUNTER II--27...............................................................
MINIMUM SWITCH II--28..............................................................
MINIMAX END CONTROL UNITW/SENSOR II --29.........................................
MOVABLE INTERM.CONTROL UNIT WITH SENSOR II--30.................................
PART III : INSTALLATION INSTRUCTIONS
GENERAL SAFETY RULES III--1........................................................
GENERAL LAY--OUT -- COMPONENT NUMBERS -- IMPORTANT III--2/3.......................
TOOLS III--4.........................................................................
TO INSTALL ALL FEEDER PAN COMBINATIONS -- TO REMOVE THE PAN III--5/7..............
TO INSTALL THE ANTI WASTE COLLAR -- TO INSTALL THE SHUT--OFF SHELL III--8/9.........
OPT. : INSTALLATION OF THE HINGED PAN -- TO INSTALL THE GRILL LOCK III--9/10..........
TO INSTALL THE FEEDER LINE III--11...................................................
FEEDER LINE SUSPENSION III--12/13.......................................................
CENTRAL WINCH INSTALLATION III--14.................................................
TO INSTALL THE MAIN CABLE III--15/16...................................................
DRAWINGS OF SUSPENSION SYSTEM WITH CENTRAL WINCH III--17.......................
TWO SHORT FEEDER LINES WITH ONE CENTRAL WINCH III--17...........................
LINE SUSPENSION III--18...............................................................
TO INSTALL THE CONTROL UNIT AND THE MOTOR -- POWER UNIT SUSPENSION III--19.....
TO INSTALL & SUSPEND THE 100KG HOPPER III--20......................................
TO INSTALL THE INTERMEDIATE CONTROL -- TO INSTALL THE TUBE WITH HOLE III--21....
TO INSTALL THE AUGER III--22/23.........................................................
TO INSTALL THE THUMPER (OPTION) III--24.............................................
TO INSTALL THE ANTI----SWINGING CLAMP&HIGH ANTIROOST PLATE (OPTION) III--25......
TOINSTALLMINIMAXCONTROLUNITWITHSENSOR(OPTION) III--26........................
TOINSTALLTHEANTIPERCHCABLE III--27/28................................................
TO INSTALL THE FLEX AUGER FEED SUPPLY SYSTEM III--29..............................
TO INSTALL THE TELESCOPICAL TUBE III--30...........................................
ELECTRICITY .... WATCH OUT ! III--31...................................................
ELECTRICAL SYMBOLS III--32..........................................................
WIRING DIAGRAM FOR SINGLE PHASE MOTORS III--33...................................
WIRING DIAGRAM FOR THREE P HASE MOTORS III--33...................................
WIRING DIAGRAM FOR CONTROL PANEL W/TIME CLOCK III--34..........................
GENERAL CONNECTION DIAGRAM (SINGLE PHASE) III--35...............................
GENERAL CONNECTION DIAGRAM (THREE PHASE) III--36................................
ELECTRICAL CONNECTION OF THE WINCH MOTOR (3--PHASE) III--37......................
CONNECTION & WIRING DIAGRAM OF THE WINCH MOTOR (SINGLE PHASE) III--38.........
GENERAL TERMS AND CONDITIONS OF SALE